Ik vind synthol nogal prijzig.
Voor een maand protocol heb je al snel 500ml nodig.
En dat kost bijna 300E
Bah veel te duur voor wat gesterilseerde kokosnoot olie lijkt mij. :eek:
Dus kwam ik op het geweldige idee om die shizzle zelf te brouwen :D
Ik heb een handleiding gevonden:
Directions For Making Synthol
WARNING: This is not intended for injection. This is a very dangerous pratice.This is a posing oil.
I suggest you get the following:
1)a few STERILIZED 150ml vials
2)5ml BA for every 100ml of oil
3)1000ml MCT oil
4)a ton of alcohol pads
5)box of syringe/pins(23g/3cc)-don't use slin and get at least 1-inchers
6)box of pins(23g)
7)filters( should be able to do more than 100ml of oil since it has no AS suspended in it)
8)large syringes for filtering. I use 60ml.
DIRECTIONS
1)attach drawing pin to 60ml syringe.
2)draw 3ml of BA into the large 60ml syringe
use 1ml of Ba for every 20ml of MCT oil
3)Now draw some MCT oil to fill the syringe.
4)hold the syringe with the needle pointing upward and remove the drawing pin
5)attach a .45 or .22 filter to the syringe
6)attach a fresh drawing pin to the filter
7)wipe the top of the sterile 150ml vial with a new alcohol pad.
8)place a pin size 23g or smaller into the rubber membrane of the vial to relive air pressure
9)insert the needle attached to the filter and syringe into the sterile vial.
10)Press slowly on the syringe with only enough pressure to push the oil through and not more than that.More pressure does not help.
11)remove the filter from the pin attached to it and leaving the pin in the sterile vial.
12)attach the drawing pin used to draw oil and draw more oil and BA using 1ml of BA per 20ml of MCT oil
13)remove drawing pin and attach the filter to the drawing pin left in the sterile vial
14)repeat steps 10-12 until the vial is full.
15)when the vial is full remove both pins from the vial and wipe the top with a fresh alcohol pad
Nu.
Zijn er hier mense die ervaring hebben met dit soort dingen?
Ik begrijp ongeveer alles maar het stuk over de filters niet
Die filter moet op de spuit begrijp ik? Welke filter is dit?
En waar in hemelsnaam vind je een spuit van 60ML? :eek:
Voor een maand protocol heb je al snel 500ml nodig.
En dat kost bijna 300E
Bah veel te duur voor wat gesterilseerde kokosnoot olie lijkt mij. :eek:
Dus kwam ik op het geweldige idee om die shizzle zelf te brouwen :D
Ik heb een handleiding gevonden:
Directions For Making Synthol
WARNING: This is not intended for injection. This is a very dangerous pratice.This is a posing oil.
I suggest you get the following:
1)a few STERILIZED 150ml vials
2)5ml BA for every 100ml of oil
3)1000ml MCT oil
4)a ton of alcohol pads
5)box of syringe/pins(23g/3cc)-don't use slin and get at least 1-inchers
6)box of pins(23g)
7)filters( should be able to do more than 100ml of oil since it has no AS suspended in it)
8)large syringes for filtering. I use 60ml.
DIRECTIONS
1)attach drawing pin to 60ml syringe.
2)draw 3ml of BA into the large 60ml syringe
use 1ml of Ba for every 20ml of MCT oil
3)Now draw some MCT oil to fill the syringe.
4)hold the syringe with the needle pointing upward and remove the drawing pin
5)attach a .45 or .22 filter to the syringe
6)attach a fresh drawing pin to the filter
7)wipe the top of the sterile 150ml vial with a new alcohol pad.
8)place a pin size 23g or smaller into the rubber membrane of the vial to relive air pressure
9)insert the needle attached to the filter and syringe into the sterile vial.
10)Press slowly on the syringe with only enough pressure to push the oil through and not more than that.More pressure does not help.
11)remove the filter from the pin attached to it and leaving the pin in the sterile vial.
12)attach the drawing pin used to draw oil and draw more oil and BA using 1ml of BA per 20ml of MCT oil
13)remove drawing pin and attach the filter to the drawing pin left in the sterile vial
14)repeat steps 10-12 until the vial is full.
15)when the vial is full remove both pins from the vial and wipe the top with a fresh alcohol pad
Nu.
Zijn er hier mense die ervaring hebben met dit soort dingen?
Ik begrijp ongeveer alles maar het stuk over de filters niet
Die filter moet op de spuit begrijp ik? Welke filter is dit?
En waar in hemelsnaam vind je een spuit van 60ML? :eek: